What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 02:07

At one ohm, the resistor has a maximum of 1 watt power.
2024–10–14 [Omar Gharbi Omar Gharbi ]
What does a fuse do?
What is your review of House of the Dragon, season 2, episode 8, "The Queen Who Ever Was"?
But… the neutral is now “floating” because of the 1 ohm resistance.
A fuse is a non-resetable over current circuit protector.
An AC voltage/ current source, and an ac inductive load.
If Trump were to lose in 2024, would that be the end of his grip on the Republican Party?
What is lightning?
but this device (an Inductor) … impedes the rapid changes in the current.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
How do Flat Earthers explain time zones?
eight
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When was the first time your wife had beastiality?
In schematic diagrams this is the symbol for a fuse:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Why is only the left side of my vagina bleeding, on and off?
He then describes Rainy Season and Lightning.
but I think this circuit , shows a few more pieces.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Bessent Emerging as a Contender to Succeed Fed’s Powell - Bloomberg
Because the load is inductive, the current lags the voltage.(by a bit).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
what exactly is a ‘surge’ protector?
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Now when you have a certain ac resistance, then a current flows in a loop.
the problem then depends on "how fast does the fuse operate?".
One is “what exactly is in a ‘surge protector’ ? ”
My boyfriend won’t tell me his past and it hurts me so I broke up with him what do I do?
It seems Mohan does not understand the difference between a comment and an Answer.
This one hit behind the barn.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Barnstars:
2024–10–10[John johnson John Johnson ]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is where this question deviates from being a 'generic' question, and becomes more specific.
I post the exact comment here.
Can people who have never met you tell if you are a covert narcissist?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The third is lightning and “how it gets conducted into a home.”
These devices are installed between the “hot” and “neutral” and protective ground.
Did Obito ever fully redeem himself in everyone's eyes?
The MOV will conduct when the voltage exceeds 50% of line voltage.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
[old diagram got deleted by accident]
Are you afraid of being alone?
For this case there are devices called Metal oxide varistors (MOV).
A circuit breaker is similar, but is resettable.
This is 'the assistant's answer'
Why does a narcissist act like it's nothing when they hurt you?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
[image of Common-mode choke]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
One
(Dc diagram shown, AC is similar).
The bolt then partially travels down the line to your home.
This device then solves the entire problem.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
a photo is worth a thousand words.
Edit 2024–10.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It also is a device that limits the change in current flow.
At least they know the answer if they wanted it.
There are two important concepts here.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
so, what happens?
First Sentence:
There are three different concepts here that are getting confused.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But it can get overloaded, and no longer works.
He then describes the function of a fuse.
The other is “what does a “fuse” do?”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
nine
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then asserts :
Upvotes:
This is where the MOV conducts again, and dissipated the energy.